The Western Canada Sedimentary Basin underlying most of Alberta contains vast mineral wealth. The geological strata not only contain oil sands, oil, natural gas and coal deposits, but also a large variety of metallic and industrial minerals.
In addition, the Canadian Shield in the northeast corner of the province consists of igneous and metamorphic rocks of Precambrian age. These are similar to those in other regions of Canada where important deposits of metallic minerals have been found.
Development of metallic and industrial mineral resources in Alberta has long been overshadowed by a focus on oil, natural gas, oil sands and coal. Although the province has more than over 40 known kinds of metallic and industrial minerals, only a few are currently being produced. Potential exists for new discoveries and the production of many other types of minerals, including:
- base metals
Much of this potential has yet to be defined. Only limited exploration and development of mineral resources other than oil, natural gas and coal has taken place. The Government of Alberta has attempted to remedy this deficiency and broaden the province's economic base in several ways:
- by providing tenure and royalty regulations that encourage mining development
- by providing extensive support services such as geological mapping and geophysical research
- by producing geoscience data, maps, reports and assessments through the Canada-Alberta Partnership on Minerals
This webpage is intended for:
- individual prospectors
- prospecting/mining associations
- companies actively involved or interested in exploring for and developing metallic and industrial minerals in Alberta
The information provides a general explanation of the steps involved in metallic and industrial mineral development. The acts and regulations that apply to this activity represent the final authorities for any administrative or regulatory procedures.
Prospecting and geophysical surveys
Prospecting for Crown minerals using hand tools is permitted throughout Alberta without a licence, permit or regulatory approval, as long as there is no surface disturbance. Prospecting on privately owned land or land under lease is permitted without any departmental approval. However, the prospector must obtain consent from the landowner or leaseholder before starting to prospect.
Unoccupied public lands may be explored without restriction. But as a safety precaution, prospectors working in remote areas should inform the local forestry office of their location.
When prospecting, the prospector can use a vehicle on existing roads, trails and cutlines. If the work is on public land, the prospector can live on the land in a tent, trailer or other shelter for up to 14 days. For periods longer than 14 days, approval should be obtained from the Land Administration Division. If the land is privately owned or under lease, the prospector must make arrangements with the landowner or leaseholder.
Exploration approval is not needed for aerial surveys or ground geophysical and geochemical surveys, providing they do not disturb the land or vegetation cover.
The prospector or company must obtain the appropriate approvals and permits if:
- mechanized exploration equipment will be used
- the land surface will be disturbed
These approvals and permits are required under the Metallic and Industrial Minerals Exploration Regulation.
Most projects require an exploration:
The following sections describe the criteria and procedures for each of these.
An Exploration Licence must be obtained before a person or company can apply for or carry out an exploration program. The licence holder is then accountable for all work done under this exploration program.
The licensee cannot carry out any actual exploration activity until Alberta Environment and Parks (AEP) Protection unit issues an Exploration Approval for each program submitted under that licence.
The licence application must be accompanied by a fee of $50. The licence is valid throughout Alberta and remains in effect as long as the company is operating in the province.
If a licence holder wants to use exploration equipment, such as a drilling rig, an exploration permit must be obtained. The licence application must be accompanied by a fee of $50. The permit is valid throughout Alberta and remains in effect as long as the company is operating in the province.
Table 1. Summary of Exploration Regulatory Documents
|Issue To||Purpose||Apply To|
|Exploration Licence||Company or person wanting to explore||Province-wide permission to explore for metallic and industrial minerals||Operations Division, Provincial Approvals Branch of Alberta Environment and Parks|
|Exploration Permit||Company or person wanting to operate equipment (often a contractor hired by exploration company)||Province-wide permission to operate exploration equipment||same|
|Exploration Approval||Company or person wanting to explore||Site-specific permission to conduct exploration which involves environmental disturbance||same|
Approval must be obtained if an exploration project involves environmental disturbance such as:
- bulk sampling
- cutting of grids that involve more than limbing trees and removing underbrush
Samples up to 20 kg in size may be taken for assay and testing purposes, but larger samples must be authorized the Department of Energy. The licensee does not need to hold the mineral rights for an area to apply for an exploration approval.
Project approval is through AEP. If an application has been completed and the appropriate field staff have copies of the program, approval can usually be obtained in about 10 working days.
Each application for exploration approval must be accompanied by a fee of $100 and contain the following information:
- types of minerals being explored
- techniques and equipment to be used
- expected startup and completion dates of program
- names and addresses of contractors who will conduct the fieldwork
- maps showing locations of both the existing and proposed drill, sample or excavation sites
- location of campsites and landing strips
- location of new and existing routes proposed to gain access to drill, sample and campsites
After receiving exploration approval, the prospector or exploration company may conduct the approved activity. However, if they modify their program, the designated field officer must be contacted to review and approve the changes.
A final report must be submitted to Land Management (AEP) within 60 days following completion of the exploration program. The report must show the actual fieldwork, and include a map showing the location of:
- test pits
- constructed roads
- existing trails utilized
- all other land disturbances
Mineral rights acquisition
Mineral exploration rights
A prospector or company must apply for a Metallic and Industrial Minerals Permit for mineral exploration rights to a specific area where the province owns the minerals. The application must contain a land description based on the legal land survey system in Alberta (township, range, meridian). It must also be accompanied by a fee of $625. The maximum area covered by a permit is 9216 ha (1 township). See the forms section for permits.
Any person or company may hold more than 1 permit at the same time. The initial term of a permit is 14 years, in 7 assessment periods of 2 years each.
A permit holder needs to do assessment work on the land so that the permit remains valid and in good standing with the Crown. During each 2-year period, the following needs to be spent assessing the property for the minerals listed in the application:
- $5/ha during the first 2 years (assessment period 1)
- $10/ha during assessment periods 2 and 3
- $15/ha during assessment periods 4, 5, 6 and 7
A permit holder may spend more than the required amount per year in assessment work. They can then apply to have the additional amount transferred to any remaining period of the permit.
At the end of each 2-year period, a report on the assessment work done during that time must be submitted to the Department by the work period due date of the permit or group. If more time is needed an Intent to File can be submitted to the Department in the 30 days prior to the work period due date. If an Intent to File is accepted the assessment report must be submitted no later than 60 days after the work period due date. The report must:
- describe the work results
- contain an itemized statement of expenditures
- be certified by either a professional:
- or verified and signed by the prospector
The information that should be included in the assessment report is specified in the regulation. The assessment report is kept confidential for 1 year. After that, it is kept in an open file.
If the assessment work and report are satisfactory, the next 2-year term of the permit is continued. If the permittee does not fully carry out the assessment work, or the report is unsatisfactory:
- the permit may be cancelled
- the size of the permit area may be reduced
For the purpose of filing assessment work, the regulation allows contiguous permits to be grouped and a single report submitted for the block of permits. Expenditures may then be assigned to any permits within the group. Once assigned to a permit, however, the assessment expenditures may not be transferred.
There may be circumstances where a permit holder is unable to conduct enough work on a permit or permits to meet the assessment requirements. The regulation allows a permit holder to pay to the Minister an amount equivalent to the assessment that would be required to continue holding the permit, once during the permit’s term.
Allowable assessment work
The kinds of work that may be submitted to the Department as assessment work include:
- stripping and trenching
- geological survey
- geochemical survey
- geophysical survey
- transporting drill core to core storage facility
- reclamation of disturbed sites
- assay and analytical work
Metallic and Industrial Mineral Leases
A permit holder must meet the terms and conditions of the Metallic and Industrial Minerals Permit. Then they may apply for a Metallic and Industrial Minerals Lease for all or part of the location.
Under certain circumstances, a lease may be granted without exploration work having been done, if the Department agrees the work was not needed. This lease gives the leaseholder the exclusive right to recover the Crown’s metallic and industrial minerals within the specified location.
The application must be accompanied by a fee of $625 and the annual rental of $3.50 per hectare. The lease is valid for 15 years. It can be renewed if the property is in production or if the Department has approved a development plan for the lease. See the forms section for a lease application.
Figure 1. Alberta Township Survey
On the Alberta Energy website, the Department publishes maps that show availability of metallic and industrial mineral rights in Alberta. There are 2 types of maps, normally updated overnight.
The interactive map is normally updated every day at around 4 am Mountain Standard Time (MST). It is recommended as a more accurate and comprehensive source map when selecting lands for the purpose of applying for metallic and industrial mineral rights.
The interactive map allows the user to:
- customize their view of the map
- obtain text reports on agreements and restrictions
- print results
The PDF map provides a static image of mineral rights availability for the whole province. It is normally updated by 11 am MST, Monday through Friday. Check the bottom left hand corner of the PDF map to confirm when it was last published.
Searches of agreements
Detailed and current information on the status, location, registered holders and term of mineral agreements may be obtained through the Calgary Information Centre. Standard searches can be conducted either by land description or agreement number.
Searches are also conducted by private land information companies. These searches may be more varied than those performed by the Department of Energy or be tailored to the specific needs of certain types of inquiries. There is a charge for searches, whether conducted by the department or a private land information company.
Before companies proceed with exploration and development, they should be made aware of any environmental concerns in their area of interest. All applications for metallic mineral rights are referred to relevant departments for review. The departments will assess potential or existing environmental concerns on the land outlined in the application.
The applicant is advised of any concerns identified by the departments. The name of the appropriate government person to contact for more information is also provided. If the applicant considers the identified environmental concerns to be too serious to warrant further mineral exploration or development, the applicant may cancel the application.
The Alberta government developed the Policy for Resource Management of the Eastern Slopes. It responds to the increased pressures on public lands and the need to co-ordinate the multiple uses of resources along the eastern slopes of the Rocky Mountains.
The policy, revised in 1984, provides broad direction for the management and use of public land and resources. It also provides a framework for more detailed sub-regional integrated resource planning.
An integrated resource plan presents the government’s resource management policy for public lands and resources, including minerals, within a defined area. Rather than being a regulatory mechanism, a plan is intended to be a guide for those who have responsibilities or interests in that area, including:
- resource managers
- the public
The planning process ensures that interests and concerns are identified and considered in decisions about public land management, use and allocation.
- geological mapping
- geological databases
- laboratory analyses
- information dissemination
- assessment reports
- a minerals and core storage facility in Edmonton
Geological mapping, research and general assistance
Geological and mineral resource mapping is ongoing. Between 1992 and 1995, a significant amount of new mapping and research was done through the Canada-Alberta Partnership on Minerals (MDA). This was a joint effort of the federal and provincial governments working with industry.
Geological maps were upgraded for parts of the Precambrian shield in northeastern Alberta. Data useful for diamonds, gold (and other metals), placer gold, limestone and gravel exploration were gathered for many parts of Alberta. The potential for industrial minerals in Alberta formation waters was also assessed.
Mineral core storage and examination
A drill core storage and selection program was started by the department in 1979. The submission of core drilled during exploration for metallic or industrial minerals may be required as part of the conditions of the exploration approval. Core is selected by an AGS geologist and preserved for examination by the public, industry or the scientific community.
To examine mineral exploration core samples, arrangements must be made in advance by contacting the manager of the Mineral Core Storage Facility at the AGS in Edmonton.
Core from oil, gas and coal drilling in Alberta is obtained by the AER, and is available for logging and sampling in Calgary.
AGS Publication Sales provides a variety of maps, publications and other geoscience resources for viewing and purchase.
Geological and mineral resource mapping is ongoing. Between 1992 and 1995, a significant amount of new mapping and research was done through the MDA, a joint effort of the federal and provincial governments working with industry. Geological maps were upgraded for parts of the Precambrian shield in northeastern Alberta, and data useful for diamonds, gold (and other metals), placer gold, limestone and gravel exploration were gathered for many parts of Alberta. The potential for industrial minerals in Alberta formation waters was also assessed.
Mineral assessment reports, prepared by companies and individuals to keep their metallic and industrial mineral permits in good standing, are also accessible.
A number of geological databases have been developed at the AGS, and selected ones can be purchased through AGS Publications.
The Alberta Mineral Deposits and Occurrences (AMDO) database is a metallic and industrial minerals database. It was developed from published and unpublished reports of mineral deposits and occurrences. AMDO can be purchased from the AGS.
The Athabasca Oil Sands Database contains geological information from numerous drill holes in the Athabasca area. Information from the database is available on request, or a report describing it can be purchased from the AGS. The entire Athabasca Oil Sands Database is also available for purchase from the AGS.
The Mineral Information System meta database contains information on MDA geoscience projects. Information on coal and mineral aggregate is also available through the AGS. For general information on MDA projects, or specific information on coal or mineral aggregate, contact AGS staff. Advice and addresses are available to those who wish to access geological information online.
Geophysical and remote sensing
Geophysical and satellite data can be obtained through the AGS. Petrophysical well log data for all of Alberta are available for viewing on microfiche. Similar downhole geophysical data can be obtained from the AER.
Airborne geophysical data and reports can be purchased from the Canada Centre for Remote Sensing.
To connect with the Coal and Mineral Development Unit:
Hours: 8:15 am to noon and 1:00 pm to 4:00 pm (open Monday to Friday, closed statutory holidays)
Toll free: 310-0000 before the phone number (in Alberta)
Coal and Mineral Development Unit
North Petroleum Plaza
9945 108 Street *
Edmonton, Alberta T5K 2G6
* Couriers, please report to the 2nd floor.
Calgary (drop-off location only)
300, 801 6 Avenue SW
Calgary, Alberta T2P 3W2